Forums Members Recent Posts Forums 3D Printers Introdu... ender 5 cura and supports Notifications Clear all cura and supports Last Post RSS Posts: 233 admin Admin Topic starter October 27, 2020 4:06 pm (@admin) Member Joined: 11 months ago After 2 failed attempts to print this mount I used the default settings for supports and this is the result. looks like a useable part. now i can continue adding bl touch bed leveling to our new longer lk1 This topic was modified 4 months ago by admin 1 Reply Posts: 233 admin Admin Topic starter December 7, 2020 5:23 pm (@admin) Member Joined: 11 months ago Had an issue with bed leveling and putting out bad parts. 1 followed bed level instructions2 changed print head for some reason and I actually think it was the filament, the ender 5 was just not able to make parts. This is a 4 hour run and looking good so far Reply
Recent Comments